KB ELECTRONICS, INC.
12095 NW 39th Street, Coral Springs, Florida 33065 USA
(954) 346-4900 FAX (954) 346-3377
"The Right Control
for your Application"
  

  SUBJECT: KBRG-212D vs. KBRG-213D Comparison

The KBRG-213D regenerative DC drive was designed to replace Minarik models RG300U, RG400U and RG500U regenerative DC drives.

The Penta Power version of this regenerative DC drive is the KBRG-212D. This DC drive also includes feature found on the rest of the KBRG Series, such as tach feedback, speed/torque mode selection, Enable and a Current Limit LED.

To compare the KBRG-213D and KBRG-212D, please reference the comparison chart on the following page. Features, which are different between the two DC drives, are shown in bold. If you have any questions, please contact an Applications Engineer or your Regional Sales Manager.

Sincerely,

Richard Fritts
National Sales Manager
   
 
Model KBRG-213D DC Drive KBRG-212D DC Drive
Availability OEM Product Penta Power Product
Input Voltage 115/230 Volts AC
50/60 Hz.
 115/230 Volts AC
50/60 Hz.
AP Range 1/8-3/4 @ 90 Volts DC
1/4-1 1/2 @ 180 Volts DC
 1/8-3/4 @ 90 Volts DC
1/4-1 1/2 @ 180 Volts DC
Armature Current Jumper Selectable
1.7, 2.5, 3.3, 5.0, 7.5 (ADC)
 Jumper Selectable
1.7, 2.5, 3.3, 5.0, 7.5 (ADC)
Two Wire
Start/Stop Method
 Inhibit - Close to Stop
Open to Run
 Enable - Close to Run
Open to Stop
Stopping Mode Coast to Stop
Regen to Stop
Selected by Location of
Inhibit Connection
 Coast to Stop
Regen to Stop
Selected by Jumper
and Enable Connection
Tach Feedback Not Available 7 Volts DC/1000 RPM
or 50 Volts DC/ 1000 RPM
LED Indicators Power ON (Green) Power ON (Green)
Overload (Red)
Control Modes Speed Mode Only Speed Mode
Torque Mode
(Jumper Selectable)